Bind DDNS

Description

Install and configure ISC Bind https://www.isc.org/downloads/bind/ with
full Dynamic DNS support.

On client side, install nsupdate, provide a generic provider and a recipe
to update DNS entries.

Requirements

Cookbooks and gems

Declared in [metadata.rb](metadata.rb) and in [Gemfile](Gemfile).

Platforms

• RHEL Family 7, tested on Centos

Note: it should work fine on Debian 8 but the official docker image does not
allow systemd to work easily, so it could not be tested.

Usage

Easy Setup

Add recipe[bind-ddns::server] in your run-list to install and configure
Bind. Configuration will be fetched from attributes options, zones and
keys.

To add a client, add recipe[bind-ddns::client]. nsupdate recipe will
update all records defined in records.

To see an example, look at [.kitchen.yml](.kitchen.yml).

Test

This cookbook is fully tested through the installation of a server and a client
in docker hosts. This uses kitchen, docker and some monkey-patching.

If you run kitchen list, you will see 2 suites, Each corresponds to a different
server:

• server-ddns-centos-7: Bind server
• client-ddns-centos-7: DNS client with nsupdate

For more information, see [.kitchen.yml](.kitchen.yml) and [test](test)
directory.

Attributes

Configuration is done by overriding default attributes. All configuration keys
have a default defined in [attributes/default.rb](attributes/default.rb).
Please read it to have a comprehensive view of what and how you can configure
this cookbook behavior.

Note: for fields needing an IP address, it is possible to set an interface
name, which will be resolved to its first non-local address.

Recipes

default

Call recipe client.

package

Install Bind package.

package-client

Install Bind utils package.

config

Configure Bind server: named.conf, keys and zones.
Then check configuration through named-checkconf.

service

Enable and start named service, subscribes on named-checkconf resource.

nsupdate

Call bind-ddns default provider (which call nsupdate command) based on
attribute records. See [.kitchen.yml](.kitchen.yml) for more information.

resolvconf

Set resolv.conf using server attribute.

client

Install Bind utils, configure resolv.conf if requested (by attribute
set_resolv_conf) with recipe resolvconf and call nsupdate recipe.

server

Install, configure and launch Bind. Then call client recipe.

Resources/Providers

default

Add or remove a DNS record using nsupdate:

Simple example:
ruby
bind_ddns 'test.foo' do
server ns.foo
keyname foo
secret XXXX
end


Add action :delete to delete an entry.

Changelog

Available in [CHANGELOG](CHANGELOG).

Contributing

Please read carefully [CONTRIBUTING.md](CONTRIBUTING.md) before making a merge
request.

License and Author

• Author:: Samuel Bernard (samuel.bernard@s4m.io)

Copyright:: 2015, Sam4Mobile

Licensed under the Apache License, Version 2.0 (the "License");
you may not use this file except in compliance with the License.
You may obtain a copy of the License at

    http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing, software
distributed under the License is distributed on an "AS IS" BASIS,
WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
See the License for the specific language governing permissions and
limitations under the License.